SonicWALL Secure Remote Access Solutions SSL-VPN 2000 User Manual download pdf (Page 12)

SonicWALL SSL-VPN 2000 Getting Started Guide Page 11

3. In the Interface Settings dialog box, set the IP address and netmask to:

4. Click OK. When you click OK, you will lose your connection to the SSL-VPN.

5. Reset the computer you use to manage the SonicWALL SSL-VPN 2000 to have a

static IP address in the range you just set for the X0 interface, for example, 10.1.1.20

or 192.168.200.20.

For help with setting up a static IP address on your computer, refer to “Configuring a

Static IP Address” on page 62.

6. Log into the SSL-VPN management interface again, using the IP address you just

configured for the X0 interface. For example, point your browser to

http://192.168.168.200.

Configuring a Default Route

Refer to the following table to correctly configure your default route. If you do not know

your scenario, refer to “Selecting a SonicWALL Recommended Deployment Scenario” on

page 3.

1. Navigate to the Network > Routes page.

2. Enter the IP address of your upstream gateway device in the Default Gateway field.

If you are using scenario: Set the X0 interface to:

B - SSL-VPN on an Existing

DMZ

IP Address: An unused address within your DMZ subnet,

for example: 10.1.1.240.

Subnet Mask: Must match your DMZ subnet mask.

C - SSL-VPN on the LAN IP Address: An unused address within your LAN subnet, for

example: 192.168.168.200.

Subnet Mask: Must match your LAN subnet mask.

If you are using scenario: Your upstream gateway device will be:

A - SSL-VPN on a New DMZ The DMZ you will create (for example, 192.168.200.2).

B - SSL-VPN on an Existing DMZ Your existing DMZ interface.

C - SSL-VPN on the LAN Your LAN gateway.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 85 86

No comments

SonicWALL Secure Remote Access Solutions SSL-VPN 2000 User Manual Page 12