SonicWALL Secure Remote Access Solutions SSL-VPN 2000 User Manual download pdf (Page 5)

Page 4

Applying Power to the SonicWALL SSL-VPN 2000

1. Plug the power cord into the SonicWALL SSL-VPN 2000 and into an appropriate

power outlet.

2. Turn on the power switch on the rear of the appliance next to the power cord.

The Power LED on the front panel lights up green when you turn on the

SonicWALL SSL-VPN 2000. The Test LED lights up yellow and may blink for up

to a minute while the appliance performs a series of diagnostic tests. When the Test

light is no longer lit, the SonicWALL SSL-VPN 2000 is ready for configuration.

If the Test or Alarm LEDs remain lit or if the Test LED blinks red after the

SonicWALL SSL-VPN 2000 has booted, restart the SonicWALL SSL-VPN 2000. For

more troubleshooting information, refer to the SonicWALL SSL-VPN Administrator’s

Guide.

Continue to Step



X0:

Default management port.

Provides connectivity between

the SSL-VPN and your gateway.

Console Port: Provides access

to command line interface.

(for future use)

Power LED

Test LED

Alarm LED

X2:

10/100 Ethernet

X1:

10/100 Ethernet

X3:

10/100 Ethernet

Power plug

Power switch

Exhaust fans

1 2 3 4 5 6 7 8 9 10 ... 85 86

No comments

SonicWALL Secure Remote Access Solutions SSL-VPN 2000 User Manual Page 5